USB to RS232

I want to convert the USB signal into RS 232 or BT..
Actually the output of the IRIS sensor gives the USB signal..Then by using a tiny microprocessor,
i have to convert the USB into UART.. (i.e.,) or simply we can say USB to UART converter..

So,i need to program for that microprocessor.. So i want to know that as follows

1.Is it a big task without the development kit????
2*.If not How to develop it?????
3. At last What should i look for choosing the suitable microprocessor in this project??

Parents
  • 1.Is it a big task without the development kit?
    yes, you will need to make your own hardware
    2*.If not How to develop it?
    buy a devkit and follow the instructions
    3. At last What should i look for choosing the suitable microprocessor in this project?
    I use the DigiKey search engine
    BTW SILabs have some dirt cheap chips based on the '51 that will do just this

    Erik

Reply
  • 1.Is it a big task without the development kit?
    yes, you will need to make your own hardware
    2*.If not How to develop it?
    buy a devkit and follow the instructions
    3. At last What should i look for choosing the suitable microprocessor in this project?
    I use the DigiKey search engine
    BTW SILabs have some dirt cheap chips based on the '51 that will do just this

    Erik

Children
More questions in this forum
There are no posts to show. This could be because there are no posts in this forum or due to a filter.