can we delay read and write transactions(axi4) by providing delay in register slice?

Sir

My write delay is working fine if I delay wready in my write channel. I have a doubt. If I am doing continous write and then I read continously, it is working fine(my each data word is getting delayed) but not in the case when I perform single read and single write. Is it that if I am not performing bursts(I do a single write and I read single data) the flow of data between different modules in AXI different to that to a single read and single write.

Regard

Preet Kaur Walia

Sir

My write delay is working fine if I delay wready in my write channel. I have a doubt. If I am doing continous write and then I read continously, it is working fine(my each data word is getting delayed) but not in the case when I perform single read and single write. Is it that if I am not performing bursts(I do a single write and I read single data) the flow of data between different modules in AXI different to that to a single read and single write.

Regard

Preet Kaur Walia

Hello,

I think your code might support only the 4 burst case from the description below.

always @(posedge clk) begin
  if (w_complete_ns | reset) begin
    cnt <= {C_CNT_WIDTH{1'b1}};
  end else if (whandshake_i) begin
    cnt <= cnt - 1'b1;
  end
end
always @(posedge clk) begin
  if (reset | w_complete_ns) begin
    subburst_last <= 1'b0;
  end else if ((cnt == {{C_CNT_WIDTH-1{1'b0}},1'b1}) & whandshake_i) begin
    subburst_last <= 1'b1;
  end
end

Best regards,
Yasuhiko Koumoto.