can we delay read and write transactions(axi4) by providing delay in register slice?

Hello,

don't you want to delay only the wdata for a slave, do you?

Do you want to add delay for the other signals?

Could you tell me the reason why the delaying won't work if we only delay the wready signal?

Best regards,

Yasuhiko Koumoto.

Hello,

don't you want to delay only the wdata for a slave, do you?

Do you want to add delay for the other signals?

Could you tell me the reason why the delaying won't work if we only delay the wready signal?

Best regards,

Yasuhiko Koumoto.

Sir

My write delay is working fine if I delay wready in my write channel. I have a doubt. If I am doing continous write and then I read continously, it is working fine(my each data word is getting delayed) but not in the case when I perform single read and single write. Is it that if I am not performing bursts(I do a single write and I read single data) the flow of data between different modules in AXI different to that to a single read and single write.

Regard

Preet Kaur Walia

Hello,

I think your code might support only the 4 burst case from the description below.

always @(posedge clk) begin
  if (w_complete_ns | reset) begin
    cnt <= {C_CNT_WIDTH{1'b1}};
  end else if (whandshake_i) begin
    cnt <= cnt - 1'b1;
  end
end
always @(posedge clk) begin
  if (reset | w_complete_ns) begin
    subburst_last <= 1'b0;
  end else if ((cnt == {{C_CNT_WIDTH-1{1'b0}},1'b1}) & whandshake_i) begin
    subburst_last <= 1'b1;
  end
end

Best regards,
Yasuhiko Koumoto.