• State Accepted Answer
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 350 subscribers
  • Views 3007 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

R5: Does the exception vector table reside in TCM if at 0x0000 0000

tjones95134

Hello,

If the R5's TCM is configured to reside at location 0x0000 0000 does it hold the exception vector table?

Thanks, Tom

Parents
  • 0 in reply to Ronan Synnott

    Hi Ronan and the forum,

    In the same context, I would like to know the behaviour of the system in the following scenario.

    What will happen if I configure a TCM after loading some data in that same region ?

    For example, 

    I am loading some content at this address 0x00000000.
    Then, I am configuring ATCM region register to configure the same address (0x00000000).

    Here, what will happen to the content which I loaded before configuring TCM ?

    Thanks,

Reply
  • 0 in reply to Ronan Synnott

    Hi Ronan and the forum,

    In the same context, I would like to know the behaviour of the system in the following scenario.

    What will happen if I configure a TCM after loading some data in that same region ?

    For example, 

    I am loading some content at this address 0x00000000.
    Then, I am configuring ATCM region register to configure the same address (0x00000000).

    Here, what will happen to the content which I loaded before configuring TCM ?

    Thanks,

Children