Dear All,
Would you please help me to understand why every slaves always hreadyout declared as '1' in Cortex M Design Kit and can't modify it in slave status?
I found a declaration assign hreadyouts = 1'b1;
Actually I'm trying to monitor only HWDATA and HRDATA when they are executed as the below
As you can see the above waveform, there are 4 HWDATA and 4HRDATA . But there is no way what I want to capture the only executed point. because Hready is always '1' and else signals also doesn't help much to me.
Could you guide me how I can check the only read and write event for HRDATA and HWDATA ?
Thank you Colin,
Yes, actually I was concerning that long timing path on HRDATA, But I am clear Now.
Thank you Colin again and sorry for late,