We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi Staff,
I am facing the problem on downloading step of the bit stream file in MPS3 board.
Below error messages are being printed.
Powering up system...Switching on main power...Configuring motherboard (rev C, var A)...
Reading Board File \MB\HBI0309C\AN524\an524_v1.txt
Configuring FPGA from file \MB\HBI0309C\AN524\524_t_1.bitAddress: 0x015E0000
ERROR: FPGA did not configure.Failed to program FPGA...
Powering down...Board powered down, use REBOOT to restart.
Can you please guide me to resolve this error?
Thank you
Hi Ronan,
I have an additional question.
When I connect the MPS3 board using the debug USB cable, the V2M_MPS3 drive does not appear on my system.
Do you have any suggestions for resolving this issue?
This board has been in use for several months without any problems, and we have not encountered this behavior before. However, we are now unable to use the board, and flashing the FPGA file is also failing.
Thank you and expecting your advice on this.
Can you remove the micro SD Card (this contains the V2M_MPS3) file system, and (re)write it directly from your PC?I suspect something has been corrupted there.For the FPGA not configuring error - this will need to be manually repaired.
Thank you for that advice related to SD card. I tried to format it and now it is showing up in the file system as expected.
As I informed earlier now I am in the process of contacting point of purchase for repairing the board.