Hi Staff,
I am facing the problem on downloading step of the bit stream file in MPS3 board.
Below error messages are being printed.
Powering up system...Switching on main power...Configuring motherboard (rev C, var A)...
Reading Board File \MB\HBI0309C\AN524\an524_v1.txt
Configuring FPGA from file \MB\HBI0309C\AN524\524_t_1.bitAddress: 0x015E0000
ERROR: FPGA did not configure.Failed to program FPGA...
Powering down...Board powered down, use REBOOT to restart.
Can you please guide me to resolve this error?
Thank you
Hi Ronan,
Thank you for that advice related to SD card. I tried to format it and now it is showing up in the file system as expected.
As I informed earlier now I am in the process of contacting point of purchase for repairing the board.