Hi Staff,
I am facing the problem on downloading step of the bit stream file in MPS3 board.
Below error messages are being printed.
Powering up system...Switching on main power...Configuring motherboard (rev C, var A)...
Reading Board File \MB\HBI0309C\AN524\an524_v1.txt
Configuring FPGA from file \MB\HBI0309C\AN524\524_t_1.bitAddress: 0x015E0000
ERROR: FPGA did not configure.Failed to program FPGA...
Powering down...Board powered down, use REBOOT to restart.
Can you please guide me to resolve this error?
Thank you
Hi Ronan,
Thank you for the advice.
As per your instructions I tried AN533 and it worked. See the logs below:
Cmd> rebootRebooting...Disabling debug USB..Board rebooting...
ARM V2M-MPS3 Firmware v1.4.1Build Date: Apr 28 2020
Reading Board File \MB\HBI0309C\Blinky\blinky.txt
Configuring FPGA from file \MB\HBI0309C\Blinky\blinky.bitAddress: 0x00660000FPGA configuration complete.
OSCCLK0 : 24.000000MHzOSCCLK1 : 32.000000MHzOSCCLK2 : 50.000000MHzOSCCLK3 : 50.000000MHzOSCCLK4 : 24.576000MHzOSCCLK5 : 23.750000MHz
OSCCLK setup: PASSEDGTXCLK (100): PASSED
FPGA does not support MCC<>SCC interface
FPGA does not support MCC<>SMB interface
UART0: MCC, UART1: FPGA0Releasing CB_nRSTEnabling debug USB.USB Serial Number = 5005437700080
After that I tried AN524 and it failed on FPGA configuration state. See the logs below.
Cmd>
ARM V2M-MPS3 Boot loader v1.0.0HBI0309 build 1044
Cmd>Powering up system...Programming Boot FLASH from \MB\HBI0309C\mbb_v224.ebfDevice programmed: 40%Boot FLASH updated.
Powering down...Resetting board.
ARM V2M-MPS3 Boot loader v1.0.0HBI0309 build 4628
MBbios update in progress DO NOT SWITCH OFF...Device programmed: 40%MBbios update complete.
ARM V2M-MPS3 Firmware v2.2.4Build Date: Nov 28 2023
Creating MCC_HELP.TXT
Reading Board File \MB\HBI0309C\AN524\an524_v3.txt
Configuring FPGA from file \MB\HBI0309C\AN524\524_t_3.bitAddress: 0x014A0000
Cmd> reboot
So as you suggested we will contact the point of purchase.
I have an additional question.
When I connect the MPS3 board using the debug USB cable, the V2M_MPS3 drive does not appear on my system.
Do you have any suggestions for resolving this issue?
This board has been in use for several months without any problems, and we have not encountered this behavior before. However, we are now unable to use the board, and flashing the FPGA file is also failing.
Thank you and expecting your advice on this.
Can you remove the micro SD Card (this contains the V2M_MPS3) file system, and (re)write it directly from your PC?I suspect something has been corrupted there.For the FPGA not configuring error - this will need to be manually repaired.
Thank you for that advice related to SD card. I tried to format it and now it is showing up in the file system as expected.
As I informed earlier now I am in the process of contacting point of purchase for repairing the board.