Can i observe the 1KB data that it is written over the STM AXI interface from STM ATB BUS ?
what i mean is that i want to send a 1KB data from STM AXI and observe it from the STM ATB with MIPI STPv2 format.
I just want to transfer a bulk of data into STM axi slave from one master so that i can observe it by DS-5.
dudu8,
So you literally want to write to an STM stimulus port, and read the trace out? As in, operate the STM as intended?
I wrote a couple blogs on this: Introduction to ARM's System Trace Macrocell
But I'm still not sure this is what you're actually asking for..
Ta,
Matt