SoC Design and Simulation forum single clock edge operation in AMBA AHB?

State Suggested Answer
Locked Locked
Replies 1 reply
Answers 1 answer
Subscribers 91 subscribers
Views 1973 views
Users 0 members are here

Options

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

single clock edge operation in AMBA AHB?

Harsh Barvaliya over 2 years ago

i am relatively new in arm, can anyone explain what is single clock edge operation in AMBA AHB?

Top replies

Colin Campbell over 2 years ago +1 suggested

This just means that only the rising edge of the clock is used to transfer information from source to destination, as opposed to both rising and falling edges being used (as was seen in the old ASB protocol...