Support forums

SoC Design and Simulation forum Rate Limit not working on Cortex-M7 FVP MPS2

State Not Answered
Locked Locked
Replies 2 replies
Subscribers 89 subscribers
Views 1428 views
Users 0 members are here

Options

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Rate Limit not working on Cortex-M7 FVP MPS2

Realtime Rik over 3 years ago

The rate limit setting does not seem to work on the Cortex-M7 FVP MPS2. My code seems to run way faster than wall clock time, and the rate limit setting makes no difference to the speed it runs. Has anyone seen this issue?

Top replies

Realtime Rik over 3 years ago +1

The Rate Limit checkbox on the display. It attempts to bring the performance index to 1 so that the simulation runs at wall clock speed. However the problem is that the performance index does not work...

Parents

0 Ronan Synnott over 3 years ago

I am not familiar with this setting, could you be more specific on which option you are using?
Cancel
Up 0 Down

Cancel

Reply

0 Ronan Synnott over 3 years ago

I am not familiar with this setting, could you be more specific on which option you are using?
Cancel
Up 0 Down

Cancel

Children

No data