Keil forum LPC54606 MCU trace configurations with Keil MDK using ULINK PRO DEBUGGER

State Accepted Answer
+1 person also asked this people also asked this
Locked Locked
Replies 3 replies
Subscribers 21 subscribers
Views 973 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

LPC54606 MCU trace configurations with Keil MDK using ULINK PRO DEBUGGER

TEMC over 1 year ago

Hi, Please provide info on how to utilize the trace functionality of LPC54606 MCU of NXP make using ULINK PRO debugger

Top replies

rkopsch over 1 year ago +1 verified

There is no specific trace tutorial for a LPC54606 - Please refer to a general trace introduction: "ULINKpro User's Guide" https://developer.arm.com/documentation/101416/0100/Setup-ULINKpro/Configure...

Parents

0 TEMC over 1 year ago in reply to rkopsch

Hi, thank you for the response. We have implemented the same steps mentioned in the ARM website, please check the images and tell how I can resolve the issue.
Cancel
Up 0 Down

Cancel

Reply

0 TEMC over 1 year ago in reply to rkopsch

Hi, thank you for the response. We have implemented the same steps mentioned in the ARM website, please check the images and tell how I can resolve the issue.
Cancel
Up 0 Down

Cancel

Children

0 rkopsch over 1 year ago in reply to TEMC

These images are too small, unfortunately. Also, the Trace configuration is missing (Options for Target - Debug - Settings - Trace).

If you possess a valid license key, an investigation can be triggered by opening a Support Ticket:

https://www.arm.com/support/contact-support
Cancel
Up 0 Down

Cancel