Hi, Please provide info on how to utilize the trace functionality of LPC54606 MCU of NXP make using ULINK PRO debugger
There is no specific trace tutorial for a LPC54606 - Please refer to a general trace introduction:
"ULINKpro User's Guide"
https://developer.arm.com/documentation/101416/0100/Setup-ULINKpro/Configure-Cortex-M-Devices/Trace-Configuration
Related:
"KAN332 - Using NXP i.MX RT1060 with Keil MDKKeil Application Note 332"
https://developer.arm.com/documentation/kan332/latest/
Hi, thank you for the response. We have implemented the same steps mentioned in the ARM website, please check the images and tell how I can resolve the issue.
These images are too small, unfortunately. Also, the Trace configuration is missing (Options for Target - Debug - Settings - Trace).
If you possess a valid license key, an investigation can be triggered by opening a Support Ticket:
https://www.arm.com/support/contact-support