• State Accepted Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 6 replies
  • Subscribers 21 subscribers
  • Views 1850 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Side-by-side change display in the Source Control tab

ahume

Go to Source control tab, press 'M' next to a file.  Get the side-by-side presentation but the green and red highlighting of changes is not there.  Used to be there. Mysteriously gone.  

Parents
  • +1

    Hello ahume,

    Thank you for making the Studio team aware of this.

    This is an intermittent issue, which has been reproduced with KSC v1.6.9.

    To workaround this issue, when it occurs, is to close the file in the Editor view, then reload KSC and now select the file entry from the Source Control tab once again to re-open the file in the Editor and display it with highlighting in the side-by-side presentation. You may have to do this more than once.

    I have added a ticket to the defect management system to fix this properly.

    Regards,

    Kanthan (Studio team)

Reply
  • +1

    Hello ahume,

    Thank you for making the Studio team aware of this.

    This is an intermittent issue, which has been reproduced with KSC v1.6.9.

    To workaround this issue, when it occurs, is to close the file in the Editor view, then reload KSC and now select the file entry from the Source Control tab once again to re-open the file in the Editor and display it with highlighting in the side-by-side presentation. You may have to do this more than once.

    I have added a ticket to the defect management system to fix this properly.

    Regards,

    Kanthan (Studio team)

Children