Hello, i am having trouble in flashing a simple program in to a 8051 device with a usb kit. The device i am using is a "at89c51ic2"
when i build target does not show any error or warning, but when i try to flash, this error shows up:
with this i went to the "options for target" ->"utilities" to make sure but i did not found nothing :(
this is what is the box:
"-autoisp -device $D -hardware RS232 -port COM5 -baudrate 9600 -operation MEMORY FLASH LOADBUFFER "#H" PROGRAM START RESET 00"
if anyone could help finding the problem it would be great, i am losing my mind :'(
sorry for my bad english
Where does BATCHISP (.EXE or .BAT) exist on your system? Is it properly pathed, via the PATH environment variable, that the system can find it when asked to run it?
Can you run it from the command line? ie a DOS Box brought up with CMD.EXE, or the Windows-R key
Have the ATMEL tools including BATCHISP been loaded/installed in the system?
hello and thank you for the response, the "Batchisp" was indeed the problem, see, the problem is that i dint program in this kit for a long time and since then i reset my pc, and i forgot i had to install a program called "FLIP" that is intended to help with the communication with the 8051 USB kit. After that was just put the correct path to the "Batchisp".
and it works great. it can flash the memory of the microcontroller
thank you once more :))
EuSouOVALETEbro said:it works great. it can flash the memory of the microcontroller
Jolly good!
Now please verify the solution: