Please note: We are aware of an issue affecting replies on the Arm Community forums, which may not be loading as expected.
We apologize for any inconvenience and appreciate your patience while we investigate and work to resolve the issue.
Thank you for your understanding.
I'm new to nucleo boards I got a program from my teacher that I could download it to the board, and it worked, but now whenever I download the program to nucleo-f401re I get internal command error. also I noticed something , when I connect my board to my laptop LD1 is red and LD3 is red but when I shake the usb wire a little Ld1 turns green! I'm using uvision v5.23 and I updated the board too! please help!
can't go to teacher's class those days need to tell why too?
Sounds like the cable or connector are bad if moving it affects things.
Try changing the connection options to "connect under reset", or pulling the BOOT0 pin high.
Does the teacher not have email/skype? You're taking a technology class in 2017...
thx , I fixed it by changing the option on target to pre-reset or under reset options. now it's downloaded. the program should connect to a phone via Bluetooth (I connected the Bluetooth shield) but when I search for I don't find the device
excellent - congratulations.
"but when I search for I don't find the device"
So that's a new problem/question - therefore, start a new thread
But note that this forum is specifically for discussing Keil tools - see the Overview:
http://www.keil.com/forum/
It doesn't sound like your problem has anything specifically to do with Keil tools; so you might be better on the ST forums - as it's ST products that you're talking about ...