Hello,
I have some issues with my nucleo board . I hadn't used it for a long time. Recently , i tried to handle it again but i don't succeed to download any program in the microcontroller. I get some messages error as STLink USB communication error or still No target detected . Naturally, i tried to look at potential solutions in the internet but until there the problem remains .
Need help !
Thanks in advance .
uVision V5.24.2.0 STLink Firm. version : V2.J29.M18 STM32 Debug + Mass storage
Hi , I've finally found my problem. I've compared my board to another one and i realized that the IDD connector was off . I 've just added a new connector and it works . So thanks for support .
This is an example of where using the ST-Link Utility would have helped - as that would have shown you the Target Voltage.