We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hello,
I have some issues with my nucleo board . I hadn't used it for a long time. Recently , i tried to handle it again but i don't succeed to download any program in the microcontroller. I get some messages error as STLink USB communication error or still No target detected . Naturally, i tried to look at potential solutions in the internet but until there the problem remains .
Need help !
Thanks in advance .
uVision V5.24.2.0 STLink Firm. version : V2.J29.M18 STM32 Debug + Mass storage
This is an example of where using the ST-Link Utility would have helped - as that would have shown you the Target Voltage.