• State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 22 subscribers
  • Views 1286 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

FRDM-KL05Z Download/debug

Dan Bovill

Hello All,
I have uVision 4 and a FRDM-KL05Z evaluation board. At the moment I am programming the flash by copying and pasting the .S19 file to the FRDM-KL05Z Drive.

When I try to use the Download button in the IDE I get the following message:

Error: Flash Download failed - Target DLL has been cancelled.

The only way I have of connecting the board is via USB cable. The board has Open SDA and device manager shows a Com port when the board is plugged in.

Does anyone know what settings I need to make to get dowload and debugging to work?

Thanks in advance
Dan

Parents
  • 0 in reply to Westonsupermare Pier

    Thanks for the tip.
    I went to Segger and downloaded and installed their J-Link OpenSDA. Followed instructions and downloaded and installed new firmware.
    Cycled power. New device detected. Searched for and found drivers.

    After a few false starts and more errors, I changed the right setting and it works!

    Thank You!

Reply
  • 0 in reply to Westonsupermare Pier

    Thanks for the tip.
    I went to Segger and downloaded and installed their J-Link OpenSDA. Followed instructions and downloaded and installed new firmware.
    Cycled power. New device detected. Searched for and found drivers.

    After a few false starts and more errors, I changed the right setting and it works!

    Thank You!

Children
No data