Hi all!
I bought Segger J-Link JTAG and I wanted to make a try with Logic Analyzer. I have unlocked debug state of my STM32F107 as described in Keil Help, made a simple while loop with incrementation like shown below: lh4.ggpht.com/.../trace1.jpg
and after I have run my program for several seconds, stopped it and I found I didnt record any result. I start and stop for several times, and that are the only positions Logic Analyzer recorded: lh4.ggpht.com/.../trace2.jpg
As you can see my trace have NOT been overflowed, and my debug settings looks like this: lh4.ggpht.com/.../trace3.jpg
even if I set more trace ports it is always the same :(