Hi all!
I bought Segger J-Link JTAG and I wanted to make a try with Logic Analyzer. I have unlocked debug state of my STM32F107 as described in Keil Help, made a simple while loop with incrementation like shown below: lh4.ggpht.com/.../trace1.jpg
and after I have run my program for several seconds, stopped it and I found I didnt record any result. I start and stop for several times, and that are the only positions Logic Analyzer recorded: lh4.ggpht.com/.../trace2.jpg
As you can see my trace have NOT been overflowed, and my debug settings looks like this: lh4.ggpht.com/.../trace3.jpg
even if I set more trace ports it is always the same :(
If you read my first post and clicked on third image you would know I read ALL the manuals and configured everything properly. It is pointless trying to help everyone by coping manuals into the threads. We read it!
At the moment it came up uVision is not compatible with J-Link.