HI, I have made a small program on 89c51 to light an led..the entire setup is made on a breadboard.. but there is no response or proper output.
The same 89c51 is working on my project kit accurately.
what is the issue with bread board and 89c51?
When designing with a breadboard, it is usually best to design with a chip with PLL so an external crystal can run at a quite low frequency, or to use an internal RC oscillator.
Then you can usually get quite good function, as long as you do not need high-quality analog sections - for example many bits of precision on ADC.
Thanks..i hav got it work ..though not entirely..need to amplify some outputs... its like a miracle..it worked today after more than two weeks of failure..