This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SIMULATION

Hello, I have a problem simulating the ADuC7026's bau rate generation, I'd configured the UART to operate at 9600 bps, but when I debugged it says that generates 4800 bps...
What I'm Doing Wrong?

Thanks

JuanMa

Parents

0 Juan Manuel IbaÃ±ez over 17 years ago in reply to ImPer Westermark

ahhh, I didn't know that about CR+LF. Yes it's 41,8Mhz, but I find the problem! It was PLL Setup, CD it was by default at 1, so cleared it.

Thanks for your attention!!

JuanMa
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Juan Manuel IbaÃ±ez over 17 years ago in reply to ImPer Westermark

ahhh, I didn't know that about CR+LF. Yes it's 41,8Mhz, but I find the problem! It was PLL Setup, CD it was by default at 1, so cleared it.

Thanks for your attention!!

JuanMa
Cancel
Vote up 0 Vote down

Cancel

Children

No data