signal record on the analog inputs

If you need to talk with someone, I think your teacher would be a good idea. He gets feedback from the other students too.

Record a number of samples and print to the serial port. With enough baudrate, you might be able to print in rea-time. An alternative is to see if you can store a number of samples in a RAM array and print. You don't need to seem many samples to verify that your ADC picks up valid samples.

You can also collect min/max/average/standard deviation and print - that gives you information about what the ADC picks up.

The number of poles should not represent a problem - it just affects the required sampling speed. But you still don't need to save anything in EEPROM. Your fight with the EEPROM may take more time than to actually do what the required work. Doing extra is a good way to learn - but that obviously requires that it is YOU who do that extra work. Asking for other people to chip in to solve problems you do not need to be solved is quite counterproductive, don't you say?

If you need to talk with someone, I think your teacher would be a good idea. He gets feedback from the other students too.

Record a number of samples and print to the serial port. With enough baudrate, you might be able to print in rea-time. An alternative is to see if you can store a number of samples in a RAM array and print. You don't need to seem many samples to verify that your ADC picks up valid samples.

You can also collect min/max/average/standard deviation and print - that gives you information about what the ADC picks up.

The number of poles should not represent a problem - it just affects the required sampling speed. But you still don't need to save anything in EEPROM. Your fight with the EEPROM may take more time than to actually do what the required work. Doing extra is a good way to learn - but that obviously requires that it is YOU who do that extra work. Asking for other people to chip in to solve problems you do not need to be solved is quite counterproductive, don't you say?

one of the specifications is to record(to see if is low and high) the signal at the maximum speed(6000/min) of motor at both sensor chanel and to see time diferents

Your second attempt at specifications:
"OK
I write here all I have and what I want

I use mc Infineon SAB 80C535
eprom is 27SF512
ic2bus is PCF8574
ADC max1168

and i must record on 2 inputs teh signal from 2 hall sensor (0 volt 12 V) and the motor are 6000 rotation/minute..."

I can't see anything that claims that you need to "record(to see if is low and high) the signal at the maximum speed(6000/min) of motor at both sensor chanel and to see time diferents".

Why are you constantly posting subsets of the specification that does not cover the parts that you request help with?

what do you think?
is posibile to make that with my mc board?

It is possible to do it with your board but you will have to write some code before it will work the way you want it to.

but you must read the datasheets first.

is better method to try to work with impuls (low, high) onn digital inputs??