He at All I have a big problem on board MCB2300 with LPC2368 When open the enviroment uVision and chk the ulink2 setting any time not show the "Jtag device chain" any time press more time the reset bottom the sistem work. But if load the program with flashmagic it work well erase load but after the program load example Blink not start , the dispaly show one row only but the program not run, any time the program start. what is this problem? The power is correct is 3,3 volt Franco
I have investigation and when with oscilloscope test the point on is conected the main oscillator at 12Mhz the program run. Now iI chk if the problem is in the crystal or in the capacitor C32 or C33
Franco
You can also disable the oscillator by software in Startup.s. Your problem might be therefore not a hardware issue, but a pure software problem.
How did you create the HEX file that you download with FlashMagic. Is this HEX file really identical with the program that you download using ULINK?
Thanks For disable the extern oscillator, where is exact the line where is enable/disable the ext main oscillator?
The datasheet would mention the name of the register that selects main oscillator.
Do you guys think it possible that the processor is being reset when the oscilloscope probe is touched to the oscillator pins, thus allowing the processor to restart and then run sucessfully?
If so, then it would seem that cycling the power would acheive the same result.
Just a thought.
Best Regards to All,
-=Rich=-