He at All I have a big problem on board MCB2300 with LPC2368 When open the enviroment uVision and chk the ulink2 setting any time not show the "Jtag device chain" any time press more time the reset bottom the sistem work. But if load the program with flashmagic it work well erase load but after the program load example Blink not start , the dispaly show one row only but the program not run, any time the program start. what is this problem? The power is correct is 3,3 volt Franco
Do you guys think it possible that the processor is being reset when the oscilloscope probe is touched to the oscillator pins, thus allowing the processor to restart and then run sucessfully?
If so, then it would seem that cycling the power would acheive the same result.
Just a thought.
Best Regards to All,
-=Rich=-