He at All I have a big problem on board MCB2300 with LPC2368 When open the enviroment uVision and chk the ulink2 setting any time not show the "Jtag device chain" any time press more time the reset bottom the sistem work. But if load the program with flashmagic it work well erase load but after the program load example Blink not start , the dispaly show one row only but the program not run, any time the program start. what is this problem? The power is correct is 3,3 volt Franco
Thanks For disable the extern oscillator, where is exact the line where is enable/disable the ext main oscillator?
Franco
The datasheet would mention the name of the register that selects main oscillator.