This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cyclone-V Development kit can't connect to the DS-5 client

I got a new 3-years license for ARM DS-5 software, I am using the "Cyclone V Development kit", but it seems can't run any project as the DS-5 fails to connect to the board, please check the snapshot below. I am wondering if this error was caused by the license, or should I activate a feature in the software, or it is related to the setting of the board, or something else? thanks for any advice in advance.

Top replies

Parents

0 Mohammed_Lami over 3 years ago in reply to Ronan Synnott

Hi, thanks for your answer

The problem has been solved after opening a support case, I figured out that the license that I bought is applicable only for the newest versions of the Intel development studio software, thanks for your support.

Regards
Cancel
Vote up +2 Vote down

Cancel

Reply

0 Mohammed_Lami over 3 years ago in reply to Ronan Synnott

Hi, thanks for your answer

The problem has been solved after opening a support case, I figured out that the license that I bought is applicable only for the newest versions of the Intel development studio software, thanks for your support.

Regards
Cancel
Vote up +2 Vote down

Cancel

Children

No data