Hello to all,
While working on different assembly instructions, I have come across a very different problem of the register's place. For example:
SBC r11,r7,r11 : 3.0217mAmps
but
SBC r11,r7,r7 : 2.7477mAmps
Similarly, for ORN and MVN also.
For all these (SBC, ORN, MVN) instructions.If
SBC Rd,Rn,Rd
or
ORN Rd, Rn, Rd
MVN Rd, Rd,
then the current consumption is comparatively high. This was seen only for these three instructions. Does anyone know about such behavior, present for these instructions?
I am working on ARM Cortex-M4.
Thanking you,
Regards,
Himanshu
Dear Mr. Yiu,
Thank you very much for your quick reply. Regarding the instructions used, I have used all 32-bit instructions only. So, I guess then the other reason could be the possible reason in my case.