• State Accepted Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 4 replies
  • Subscribers 351 subscribers
  • Views 8003 views
  • Users 0 members are here
2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cortex-M7 minimum schematic ?

dgubber

I'm looking to start a new design based on the ARM Cortex-M7 and have been reading thousands of pages of documentation ( not done yet of course ). I am able to design my own schematics and PCBs so I'm trying to first determine the very bare minimum to start.

1. power circuits to accommodate a ATSAMV71Q21

2. the ATSAMV71Q21 itself

3 USB circuits to attach the board to a PC

I may be wrong, but my understanding thus far is that the SAM V71 embeds an Internal ROM for the SAM Boot Assistant (SAM-BA), In Application Programming functions (IAP) and Fast Flash Programming Interface (FFPI), ( <- right from the doc ) and that this sets up serial communication via the UART0 and USB.

Initially I would simply be using the internal ROM, embedded FLASH and SRAM ( although I might add in an external 16Mb SRAM chip ).

Granted, this minimum configuration wouldn't be able to do much as there would be no external peripherals just yet, but my plan would be to connect a series of header pins for testing purposes.

Any feedback would be greatly appreciated.

Thanks in Advance.

 

Parents Reply Children
  • 0 in reply to Joseph Yiu
    Joseph, thank you for your reply.

    First is that I have been using the SAMv71 Xplained Ultra documents and schematics as reference and through that, I&#x27;ve been able to compile what I believe is in fact a minimal circuit, which currently includes a ATSAMV71Q21 ( ARM Cortex-M7 ), IS42S16100E ( 16-MBIT SDRAM ), Power circuits and a Micro-USB connector tied back to HSDM, HSDP and USB_ID respectively. Also included is the necessary crystals, filter caps, etc

    By reading the ATSAMV71Q21 documentation as well, it appears to indicate that the internal ROM already has code for the SAM Boot Assistant (SAM-BA), In Application Programming functions (IAP) and Fast Flash Programming Interface (FFPI) and that this code sets up the USB and USART ports for use. ( obviously not real worried about the USART as long as I have USB functionality ).

    I will also start looking at the Atmel community site.