• State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 350 subscribers
  • Views 1136 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

the timestamp during the kernel boot not correct

huoyan

I set the frequency of the system counter to 20MHz: by set cntfrq_el0

dmesg:

arch_timer_of_init, rate 20000000

arch_timer: cp15 timer(s) running at 20.00MHz (phys).

but in dmesg, the time shows take 10 seconds to finish the boot,

but in fact, it is 3 mins which I count by my iphone.

does anyone can tell the reason?

since it is a arm board, I can't get the cpu freq though /proc/cpuinfo, 

processor : 0
BogoMIPS : 40.00
Features : fp asimd evtstrm crc32 cpuid
CPU implementer : 0x41
CPU architecture: 8
CPU variant : 0x0
CPU part : 0xd03
CPU revision : 4

Hardware : Rockchip RK3568 EVB1 DDR4 V10 Board
Serial : 0000000000000000

Parents
  • 0

    dmesg should count the Linux kernel time only? When start_kernel() is not executed, the cntfrq_el0 timer is not started?
    While you iphone time will calculate the time when you pressed the board Power On button?  It takes much time for the Board Firmware to launch Linux kernel and this time may be ignored by you.

Reply
  • 0

    dmesg should count the Linux kernel time only? When start_kernel() is not executed, the cntfrq_el0 timer is not started?
    While you iphone time will calculate the time when you pressed the board Power On button?  It takes much time for the Board Firmware to launch Linux kernel and this time may be ignored by you.

Children
No data