• State Accepted Answer
  • Locked Locked
  • Replies 9 replies
  • Answers 1 answer
  • Subscribers 351 subscribers
  • Views 5993 views
  • Users 0 members are here
2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

STM32F103RB (Cortex M3): Connecting to CPU via connect under reset failed after flashing a deep sleep mode manager software

Nidhal Ben Othmen

Hello,

I am using an STM32F103RB MCU in a specific Hardware design.

The Hardware was always working fine until I flashed a software which implements the stop mode (deep sleep mode) management (it's a low power mode supported by ST by setting the SLEEPDEEP bit in the System control register (SCB_SCR) supported by ARM).

In the Software after calling the set instruction WFI (wait for interrupt) to wait for an interrupt to wake-up the micro-controller, it still sleeping for ever.

In debug session (using j-link as debugger via SWD) by pressing next step in IAR, I can go out from deep sleep mode.

When I go out from debug session I can't connect anymore to the micro-controller and I can't flash it anymore.

I have the issue as described in the screenshot.

I am really stick with this and I look forward your help !

Best regards,

0