Question for AXI responce when access error

Hi Garo,

as you say, the early is not AXI compliant. However I must correct myself a little. My answer of yesterday was valid for a read responce. As for a write response the BRESP values should be the same in a burst transaction according to the "AMBA® AXI™ and ACE™ Protocol Specification (ARM IHI 0022D (ID102711))".

A3.4.4 Read and write response structure

For a write transaction, a single response is signaled for the entire burst, and not for each data transfer within the burst.

In a read transaction, the slave can signal different responses for different transfers in a burst. For example, in a burst of 16 read transfers the slave might return an OKAY response for 15 of the transfers and a SLVERR response for one of the transfers.

The followings are my comments.
An AXI master can check only the BRESP of the last responce for a write.
Regarding the early BRESP, you can ignore AWUSER[8] and can return write responces as normally. AWUSER[8] only indicates the master can accept the early BRESP.

Best regards,
Yasuhiko Koumoto.

Hi Garo,

as you say, the early is not AXI compliant. However I must correct myself a little. My answer of yesterday was valid for a read responce. As for a write response the BRESP values should be the same in a burst transaction according to the "AMBA® AXI™ and ACE™ Protocol Specification (ARM IHI 0022D (ID102711))".

A3.4.4 Read and write response structure

For a write transaction, a single response is signaled for the entire burst, and not for each data transfer within the burst.

In a read transaction, the slave can signal different responses for different transfers in a burst. For example, in a burst of 16 read transfers the slave might return an OKAY response for 15 of the transfers and a SLVERR response for one of the transfers.

The followings are my comments.
An AXI master can check only the BRESP of the last responce for a write.
Regarding the early BRESP, you can ignore AWUSER[8] and can return write responces as normally. AWUSER[8] only indicates the master can accept the early BRESP.

Best regards,
Yasuhiko Koumoto.

Hi Koumoto-san,

Thank you so much.

Let me check the document.

My slave has been response only once when it was operating both DECERR and SLVERR.

-write : My slave didn't  check for enough asserted "WVALID" cycles, and it asserted BVALID before AXI master asserted WLAST.

-read :  My slave asserted both RLAST and RVALID at next cycle of asserted RREADY.

I should re-design  my AXI slave I/F.

Regards,

-GARO