Please note: We are aware of an issue affecting replies on the Arm Community forums, which may not be loading as expected.

We apologize for any inconvenience and appreciate your patience while we investigate and work to resolve the issue.

Thank you for your understanding.

  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 348 subscribers
  • Views 6563 views
  • Users 0 members are here
Options
Related
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cortex-M3 frequency

Sorush

Hello everyone,

So I want to implement the cortex-m3 with the 0.18 TSMC library, but I can't find its maximum frequency. Does anyone know the maximum frequency for the M3 in 0.18 technology?

Parents
  • 0 Arm Employee Badge

    I would recommend you check this with your FAE. This will depend on your configuration of CM3, the library you will use, and the experience of back-end, etc. I found some data which use:

    Process = TSMC 28nm CLN28HPM
    RTL Configuration = 32 IRQs, Interrupt Priority Width 3, ETM, MPU & WIC present, 34 WIC lines, Bit-banding, Reset_all_registers 0, Full trace and debug
    Area = 0.04755 mm^2 (post optical shrink)
    Static power (mW) = 0.02926
    Frequency = 99MHz

    Please note this achieved frequency may not be the maximum and it's only for your reference.

Reply
  • 0 Arm Employee Badge

    I would recommend you check this with your FAE. This will depend on your configuration of CM3, the library you will use, and the experience of back-end, etc. I found some data which use:

    Process = TSMC 28nm CLN28HPM
    RTL Configuration = 32 IRQs, Interrupt Priority Width 3, ETM, MPU & WIC present, 34 WIC lines, Bit-banding, Reset_all_registers 0, Full trace and debug
    Area = 0.04755 mm^2 (post optical shrink)
    Static power (mW) = 0.02926
    Frequency = 99MHz

    Please note this achieved frequency may not be the maximum and it's only for your reference.

Children