I am configuring a project using nic400.
Following error message was displayed: ERROR Operation:Build IP Operation Operation: "convertAndCopyIPXACT" on configured component: "nic400_test"failed.Configuration attribute ConvertiPXACTWorkflowStep.pathTolnputFile points to afile that does not exist.
Have you seen this before? What was the cause of this error?
Where is the nic400_test? How to find what file is missing? How to set Configuration attribute ConvertiPXACTWorkflowStep.pathTolnputFile
I don't think this question can be properly addressed on a public forum.
Please raise a support case from the Support menu below.
Sure, a support case is filed.