We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
I am seeking assistance on the Arm forum to understand how the 1-bit ACTIVE signal in the Arm® Power Policy Unit Architecture Specification corresponds to different power modes, as mentioned in section 3.3.2 Q-Channel PPU Power Modes Transitions. This section discusses various transitions between power modes, but given that the ACTIVE terminal of the Q-channel interface is a 1-bit signal, how does it map to different power modes?
Any insights or explanations on this matter would be greatly appreciated. Thank you.
“SoC Design and Simulation forum”
Thanks.