Hello guys,Im trying to use the timer registers of my ARM Cortex M0 while using my pga970EVM. Unfortionally there aren't any files/Commands refering to using the 3 registers SYST_CSR, SYST_RVR, SYST_CVR. I figured out how these registers are working quite easily: SYST_CVR is set to the Reload Value which is defined by SYST_RVR. When SYST_CSR is enabled, SYST_CVR gets lowered periodically and when reaching 0 its Value is reset to the reload Value. Normally there should be a function which is called as soon as the Current Value Register hits 0 but there is none in my generic firmware. The link provides the information I have on these registers.
Cortex-M0 Devices Generic User Guide (arm.com)Do I have to write a function my own? If so how can i do it?I already tried checking the CVR hitting 0 with an if-function: if(SYST_CVR==0x00000000) but everything if this loop never got triggered.Regards, Paul
Can you determine what address NVIC_ENABLE0 is at? Is should be the ISER [0xE000E100], but could it mistakenly be the ICER [0xE000E180]?
https://developer.arm.com/documentation/dui0497/a/cortex-m0-peripherals/nested-vectored-interrupt-controller?lang=en
https://developer.arm.com/documentation/dui0497/a/cortex-m0-peripherals/nested-vectored-interrupt-controller/interrupt-set-enable-register?lang=en
https://developer.arm.com/documentation/dui0497/a/cortex-m0-peripherals/nested-vectored-interrupt-controller/interrupt-clear-enable-register?lang=en
NVIC_ENABLE0 is at [0xE000E100]