µVISION DEBUGGER: "Trace HW not present" using J-Trace on Cortex-M7 says the JL2CM3.dll JLink/JTrace debugger driver DLL from Segger used in MDK µVision doesn't yet support the trace debug functionality for all Cortex-M7 based target devices.
Now, it's about one year later. So what's the situation now?
I'm designing a PCB, and need to choose which debugger connector should use on my board, J-link or ST-Link, or U-link.
Thanks.
Please repost this to the correct forum (link below) - this area is for questions related to Arm simulation platforms, and may not be tracked by those with appropriate knowledge to address your concern:https://community.arm.com/developer/tools-software/tools/f/keil-forum
Ronan Synnott said:Please repost this to the correct forum
Is it not possible for ARM Admins to move posts - so we don't end up with a load of "dead" duplicates ?
diverger Zhang when you do re-post, please be sure to post a link here - so that people can find the new post.
Also mark this one as resolved