This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AHB Bus Protocol -- Address Phase

Hi, AHB-newbie here.

For AHB-lite is there any way that the Slave may signal to the Master that it is not ready to accept any transactions?

Driving HREADY low only extends the data phase of the current transaction.

My understanding that the MASTER always expects the respective slave to always be ready to sample the Address on the Address Phase.

Is there also any way for the slave to tell the master that the current address phase needs to be extended?

Thanks.

Parents

Reply

Children

No data