• State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 88 subscribers
  • Views 7229 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Max DMA transfer speed

Michael von Hauff
Note: This was originally posted on 4th January 2009 at http://forums.arm.com

My application requires that I transfer data from a external device connected via one of the gpio ports. I need to transfer data at about 40MSps. 8 bit samples.

From what I have read about the DMA controller, I can get transfers at 1/4 the clock speed (1/4 of 72MHz). Is that correct? I was think of pulling in two samples at a time (use a 16bit buffer).

Also, if I want to get data from the GPIO port, what would be the dma configuration that most makes sense? My external device is a A/D. I have to clock it somehow. assuming I can use any peripheral to drive the dma which should I use?


Thanks!
Parents
  • 0
    Note: This was originally posted on 5th January 2009 at http://forums.arm.com

    Hi, sorry for the lack of info (was late when i posted)

    I am using a cortex M3. Currently I am using an eval board from STMicro, but we aren't fixed on using STMicro's product.

    From the data sheets, the gpio ports can be configured to run at upto 50Mhz.

    The limiting issue that I see is that the DMA runs at 1/4 the main clock speed.

    What I was planning to do was buffer the incoming 36MSps 8bit data into a 16bit buffer and read in two samples per dma transfer cycle (at 18MHz).

    Does that sound doable (i have never used dma before so i may be totally mistaken in whats possible)?

    Thanks
Reply
  • 0
    Note: This was originally posted on 5th January 2009 at http://forums.arm.com

    Hi, sorry for the lack of info (was late when i posted)

    I am using a cortex M3. Currently I am using an eval board from STMicro, but we aren't fixed on using STMicro's product.

    From the data sheets, the gpio ports can be configured to run at upto 50Mhz.

    The limiting issue that I see is that the DMA runs at 1/4 the main clock speed.

    What I was planning to do was buffer the incoming 36MSps 8bit data into a 16bit buffer and read in two samples per dma transfer cycle (at 18MHz).

    Does that sound doable (i have never used dma before so i may be totally mistaken in whats possible)?

    Thanks
Children
No data