• State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 88 subscribers
  • Views 5516 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AHB Arbiter

vishalrane vishalrane
Note: This was originally posted on 21st November 2008 at http://forums.arm.com

Y is it necessary to provide HADDR input to the arbiter in AHB bus protocol ?
Parents
  • 0
    Note: This was originally posted on 21st November 2008 at http://forums.arm.com

    Y is it necessary to provide HADDR input to the arbiter in AHB bus protocol ?


    Hi Vishal,

    With reference to the AMBA AHB rev 2.0 :
    Signals defined for the arbitration are: HBUSREQx , HLOCKx , HGRANTx , HMASTER , HMASTLOCK and HSPLIT.
    Though in the interface diagram all the address and control signals are shown.

    It is not necessary to provide them to the arbiter.
    I hope this answers to your question.

    Regards,
    chintan
Reply
  • 0
    Note: This was originally posted on 21st November 2008 at http://forums.arm.com

    Y is it necessary to provide HADDR input to the arbiter in AHB bus protocol ?


    Hi Vishal,

    With reference to the AMBA AHB rev 2.0 :
    Signals defined for the arbitration are: HBUSREQx , HLOCKx , HGRANTx , HMASTER , HMASTLOCK and HSPLIT.
    Though in the interface diagram all the address and control signals are shown.

    It is not necessary to provide them to the arbiter.
    I hope this answers to your question.

    Regards,
    chintan
Children
No data