We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi
I want to connect the Xc2787 chip with keil uvision5 and with ulink 2 or miniwiggler programmer but i have a problem.
this chip seems have two jtag port connection which is:
port A:
tms_a : pin39 / tdo_a: pin8 / tdi_a: pin34 / tck_a: pin 82
Port B:
tms_b: pin 118 / tdo_b: pin 121 / tdi_b: pin 117 / tck_b: 115
We connected vref and treset and ground and reset on both port a and port b but when we press the start/stop debug session, it will say that the jtag device is not connected.
I have checked the tms and tdi and tck pins via Oscilloscope and i saw that these pins have pulse except tdo pin when i start the debug session
here is the link of the chip datasheet for you:
https://www.infineon.com/dgdl/Infineon-SAK-XC2787X-200F100L%20AB-DataSheet-v01_03-en.pdf?fileId=db3a304328c6bd5c012912087ab5098e
please help us to how to connect this chip to ulink2 or miniwiggler.
Best regards
Good luck