This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NOT ABLE TO LOAD FLASH AND DEBUG CODE

I have nucleog0b1re development board. i am not able to debug the codes as ide immediately closed as i start debug session. This code is runnning fine in other ide. i have downloaded all software cmsis file for stm32g0b1re. still not able to find the problem can anyone suggest what could be the problem?

Top replies

rkopsch over 1 year ago +2 verified

In case that you have selected an ST-Link debug adapter + Keil MDK 5.38a follow "MDK uVision crashes when using ST-Link debugger" developer.arm.com/.../latest
SS25 over 1 year ago in reply to rkopsch +1

thank you for the solution. now ST-LINK debugger working fine.
EdithMann over 1 year ago in reply to rkopsch +1

Thanks for the solution. You made my day. I also would like to help you by sharing the https://proessayservice.com/article-review-writing-service website with you. If you looking for an article review...

Parents

0 SS25 over 1 year ago in reply to rkopsch

thank you for the solution. now ST-LINK debugger working fine.
Cancel
Up +1 Down

Cancel

Reply

0 SS25 over 1 year ago in reply to rkopsch

thank you for the solution. now ST-LINK debugger working fine.
Cancel
Up +1 Down

Cancel

Children

No data