I have a new ULINK2 debugger with firmware 2.00. It is detected on uVision as CMSIS DAP. I want to switch it back to ULINK boot mode. I did follow https://developer.arm.com/documentation/101455/0100/Appendix/Utilities/Boot-Mode-Utility instruction but the command prompt shows the command:
C:\Users\xxx\Downloads\3632>UL2_Configure B0ULINK2 Configure Utility V1.0
Disconnecting ULINK ..........Connecting ULINK Loader ....................Error: ULINK Loader not detected!
Hi there, I have moved your question to the Keil forum. Many thanks.