This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Start debug error

Sometimes when I click on Start/Stop debug session, an error message appears: " Error: 'C:\Keil\ARM\BIN\SARMCM3.DLL' not found. But the file is in the folder.

What could be the problem?

Thank you

Top replies

rkopsch over 2 years ago +2 suggested

- Do you face this issue with the latest release of Keil MDK installed: http://www2.keil.com/mdk5 ? - Does this error appear after a new installation of Keil MDK? Related: ARM: "SARM.DLL NOT FOUND...
rkopsch over 2 years ago in reply to VCL +2 verified

So, please compare with the latest release of Keil MDK installed. This release is offered at: http://www2.keil.com/mdk5

Parents

+1 rkopsch over 2 years ago in reply to VCL

So, please compare with the latest release of Keil MDK installed.

This release is offered at: http://www2.keil.com/mdk5
Cancel
Up +2 Down

Cancel

Reply

+1 rkopsch over 2 years ago in reply to VCL

So, please compare with the latest release of Keil MDK installed.

This release is offered at: http://www2.keil.com/mdk5
Cancel
Up +2 Down

Cancel

Children

No data