Hi All,
I have a linker scatter file that uses "#!armclang -E --target=arm-arm-none-eabi -mcpu=cortex-m33 -xc" command in the first line to preprocess an included header file.
I've noticed a couple issues that I am not sure the best way to resolve within the KEIL environment.
First is that the header file in not found unless I include the path in the previously mentioned preprocessor command by adding "-I..\..\Linker" to the command.
The second issue is that the header file has references to definitions that are at the project level.
I suspect that both of these issues are related to the fact that the project level settings are not being seen during the linker stage. Is there a way to have the C\C++ include directories and #defines from the project be included during the linker scatter preprocessing?
Thanks for any help!
ChenTang This manual page is good for understanding how to get the preprocessor to run on the scatter file (Which I have no problems doing). The question is "Is there a way to have the KEIL project definitions (Defined in the KEIL project c/c++ settings) to be visible when the preprocessor runs on the scatter file?" I want the defines highlighted in yellow in the picture below to be visible to the preprocessor when processing the scatter file.