• State Accepted Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 1 reply
  • Subscribers 20 subscribers
  • Views 2192 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Debugging of multiple target chips based on JTAG Daisy-Chain connection

Tem

Question 1: Jlink is connected to the two chips of the Cortex-M3 core through the JTAG Daisy-Chain connection. Keil can recognize the ID, but debugging and downloading are unsuccessful, unless the nRESET pin of the chip is connected to the nRST pin of Jlink, but the above The connection method is stated in the Jlink document to connect the TRESET pin of Jlink. Why?

Question 2: Jlink connects two cored chips through the JTAG Daisy-Chain connection. One chip is the ARM Cortex-M3 core, and the other is the RISCV core. Keil cannot recognize the chip ID of the ARM core, but it can be recognized by JFlash Two chip IDs, why?

Thanks