• State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 22 subscribers
  • Views 1151 views
  • Users 0 members are here
2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

STM32f103c8 ADC error, Constant error value and erratic output

VC_1

I am trying to create ADC using STM32F103C8. Software i am using are:

a. STM32CubeMX

b. Keil Vision -- V5

c. Hercules to Monitor the Serial Output

Clock Setting of STM is

 

Code  :-

while (1)
  {
    /* USER CODE END WHILE */
        HAL_ADC_Start(&hadc1);
        HAL_ADC_PollForConversion(&hadc1,300);
        raw = HAL_ADC_GetValue(&hadc1);
        float vin = (double)raw*(3.3/4096);
        sprintf(msg1,"Vol = %.2f , HEX Value = %.4x \r\n",vin, raw);
        HAL_UART_Transmit(&huart1,(uint8_t*)msg1,sizeof(msg1),300);
    HAL_Delay(1000);
    /* USER CODE BEGIN 3 */
  }

i am getting a constant DC Output of around 1.69 Volt, when input volt at ADC is Zero (Screen Shot attached). After supplying any Voltage value between 0 - 3.3 Volt, output is varying contentiously between 0 to 3.3 Volt.

I have checked the input reference volt, it is 3.3 Volt. Can you suggest me how to resolve this issue. have printed a HEX value of output of function HAL_ADC_GetValue(&hadc1).

0