This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot Load Flash Programming Algorithm STM32H743ZI

Hello

Tools:
- uVision 5.33.0.0
- ULINKpro

I try to flash or debug my STM32H743 controller. It worked for months. But now I get the following error message.

I do the following steps:

1. Check for device

2. Flash

After that I have to reconnect the USB cable to the ULINKpro to see the controller again.

Any idea?

Regards
Jakob

Top replies

Jakob Brunhart over 3 years ago in reply to Westonsupermare Pier +1 verified

Hi I could solve the probleme. I had to erase the full chip once. After that I could work againg with "Erase Sectors" and load into the flash. Regards Jakob

Parents

+1 Jakob Brunhart over 3 years ago in reply to Westonsupermare Pier

Hi

I could solve the probleme. I had to erase the full chip once. After that I could work againg with "Erase Sectors" and load into the flash.

Regards
Jakob
Cancel
Up +1 Down

Cancel

Reply

+1 Jakob Brunhart over 3 years ago in reply to Westonsupermare Pier

Hi

I could solve the probleme. I had to erase the full chip once. After that I could work againg with "Erase Sectors" and load into the flash.

Regards
Jakob
Cancel
Up +1 Down

Cancel

Children

No data