Keil forum USB HUB not working

State Not Answered
Locked Locked
Replies 5 replies
Subscribers 24 subscribers
Views 1946 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

USB HUB not working

SRIDHAR R over 4 years ago

Hi

I am developing a project using nuvoton m263ki development board and using keil IDE

The sample code of usb-host device connection check is not working properly

When i connect usb hub, it gets detected

When i connect flash drive into one of the usb-hub port, it is working

But When i connect keyboard into one of the usb-hub port, it is not working

Don't know why

Please give me your valuable answers

Thanks

R Sridhar

Parents

0 SRIDHAR R over 4 years ago in reply to Milorad Cvjetkovic

Thanks for your reply

I am getting that TD error and i don't know how to avoid it

Do you have any idea why i am getting that error?

Thanks

R Sridhar
Cancel
Vote up 0 Vote down

Cancel

Reply

0 SRIDHAR R over 4 years ago in reply to Milorad Cvjetkovic

Thanks for your reply

I am getting that TD error and i don't know how to avoid it

Do you have any idea why i am getting that error?

Thanks

R Sridhar
Cancel
Vote up 0 Vote down

Cancel

Children

0 Milorad Cvjetkovic over 4 years ago in reply to SRIDHAR R

Hi Sridhar,

It says Set address failed, perhaps you tried to assign the same address to a different device.
You should analyze your code and return error code to find out what is the reason.

Best regards, Milorad
Cancel
Vote up 0 Vote down

Cancel